Jump Guard Pro Tank Cover

Included in the kit

The Jumpguard Aquarium Cover is a kit of parts which allows the aquarist to create a custom frame for their specific aquarium. The rigid corners and extruded aluminium section create a very solid frame which sits neatly inside glass of the aquarium glass, resting on the top lip.  

Kit Contents:

Features of the NEW Jumpguard Tank Cover

NEW PROFILE DESIGN

The special extruded aluminium profile is now shaped with a lip which sits directly onto the edge of the glass, removing the requirement for any additional clips or brackets. The section is extruded then powder coated in a tough, low sheen, black finish for greater scratch resistance and greater aesthetics.

 

IMPROVED CORNER MOULDINGS

The lower section of the corners is specifically designed so that it does not interfere with the silicone bead in the corners of your tank which gives a tight fit to the glass with no gaps. It also makes it easier and neater to cut off the corner if you want to bring wires out at the back of the tank for pumps and heaters.

 

MAXIMUM LIGHT PENETRATION

For those concerned with loss of light penetration into your reef tanks, we tested light levels with a Apogee MQ-200 meter and got the following results:
PAR without cover around 390 - 400 • PAR with cover around 380 - 390 • Approximately a 2.5% reduction in light with no shadowing at all.

 

Notes:

1. The maximum size frame that can be made from each kit will be 3.6cm longer than stated in each direction.
2. The tank should be measured from inside face of glass to inside face of glass.

Pro version includes:

• 1 x flexible-cutout set.
• Brace bar systems and connectors.
• New BLACK mesh